Installation Manual

9
Install Drawer System cont...
REV_A02
Secure the middle D-ring mounts on the Drawer System to the D-rings fitted in Step 2I using a C-hook and
Turn Buckle (Items 2, 11) each side. Secure the front D-Ring mounts to the tie down rings found at the
rear of the vehicle using the remaining C-hooks and Turn Buckles. Ensure the Wing Nut goes towards the
top of the Drawer System. When tightening the Turn Buckles ensure that the Drawer System remains cen-
tered left to right and 55 mm from the front. Once the Drawer is secure in position tighten the Wing Nuts
on the Turn Buckles and the Bolts securing the D-rings to the Drawer System and the vehicle's load bay.
()
D
MIDDLE MOUNTINGS
Ensure Wing
Nut at Top
FRONT MOUNTINGS
Ensure Wing
Nut at Top
()
E
Fit the Side and Rear Decks (Items 28, 29, 30, 31) into position, by "clipping" the outer edge of the Decks
into the Wing Sliders (Items 24 & 26) and pushing the Decks towards the outside of the vehicle, thereby
adjusting the Slider to the correct length. Once you are happy with the length of the Slider, carefully re-
move the Decks taking care not to move the Sliders and fasten the two bolts on each Slider, locking it into
position.
Secure the center of the Rear Decks to the Rear Support (Item 23) using the two M6 x 25 Countersunk
Bolts and two M6 Finishing Washers (Items 37 & 38).
( F )
C-Hook
C-Hook