Installation Manual

7
Prepare for installation cont...
REV_A02
Secure the two D-rings (Item 33 received with SSDS201) to the inside of the vehicle's load bay. You will be
bolting through the two 6.5 mm holes drilled in Step 2H using two M6 x 25 Hex Bolts, four M6 x 19 Flat
Washers, two M10 x 50 Flat Washers and a two M6 Nyloc Nuts (Items 32, 34, 35, 36 received with SSDS201)
as shown.
()
I
Install Drawer System
Lift the Drawer System (Item 1) into the vehicle's load
bay and position it 55 mm in from the front of the load
bay and center it from left to right.
()
A
Tail Gate
55 mm
Load Bay