Installation Manual

3
Prepare for Fitment
Place the Drawer System into the vehicle. Work out the best position to place the Drawer System and
mark its position onto the vehicle. Remove the Drawer System.
(
B
)
Measure the distance between the centers of the front and rear sets of mounting points on the Drawer
System as shown.
()
A
Cut the Aluminium Extrusions (Item 5) to the required length and place them into the vehicle. Using your
markings from Step 2B as a guide, position the Extrusions making sure that they are, your measurement
from Step 2A, apart as shown. Once satisfied mark the position of the Extrusions onto the vehicle.
( C )
SSCA020_REV_A00