Installation Manual

Fit Drawer SYSTEM cont...

( i )

Hook a Carabiner (Item 2) onto one of the Drawer

Systems D-Rings then hook the "ring" end of the

Turn-buckle into the Carabiner (Item 5). At this point

you will see how far you need to extend the

Turn-buckle to reach the closest D-Ring on your

vehicle. Once adjusted hook the Turn-buckle onto the

D-Ring and loosely tighten. Repeat this three more

times. With all four points attached tighten the

Turn-buckles. But do not over tighten, as this may

cause the Drawer System to bow out of shape.

( j )

( l )

Congratulations, Take a step back and admire your

handy work. Good Job!

Take the Turn-buckles (Item 5) and loosen the round end of the four Turnbuckles. Screw a M6 Wing Nut

(Item 10) onto each round end. Reassemble the Turn-buckle as shown below.

Check that the drawer opens and closes smoothly without having to force it. If you have to force the

Drawer to close or open, loosen the Turn-buckles slightly. Check again. If satisfied tighten the Wing Nut

firmly as shown below by the arrow. This will prevent the Turn-buckle from loosening over time.

( k )

SSAM014_REV_A00