Installation Manual

3
Fit Drawer SYSTEM
( A )
Remove the Rear Jump seats if fitted as per your vehicles owner’s manual.
In the picture to the right, the SUV has Factory
Fitted D-Rings these will be used to secure the
Drawer System. If your vehicle does not have
Factory Fitted D-Rings move on to Step2H which
shows how to install your own fixing points.
( B )
( C )
To check if your vehicle has the appropriate fixing points, place the Drawer System in the vehicle. Make
sure you can close the door or hatch without the Drawer system touching the door or hatch. To prevent this
from happening set the drawer system as deep into the trunk as possible. Close the door or hatch gently.
From the inside of the vehicle, lean over the rear seats and adjust the drawer system so that it is plus minus
2cm away from the door or hatch. Open the back of the vehicle again. Check that the Drawer is centred in
the vehicle using a measuring tape.
With the Drawer in
position check that the
Factory Fitted D-rings
are positioned in line
with D-Rings on the
Drawer system as
indicated by the
arrows, and that
nothing will interfere
with the Turn-Buckle.
If you find that your
vehicle does not have
mounting points in the
appropriate positions
move on to Steps2D.
SSAM014_REV_A00