Installation Manual

RRAC211_REV_A00
© 2021 FRONT RUNNER VEHICLE OUTFITTERS
3
FIT AND SECURE 2
2.1
2.2
2.3
Remove the Slimsport Wind Fairing and side
support brackets.
Loosen and remove the front slat.
Remove the Wind Fairing Mid Support
Bracket that is currently on the slat and
replace it with the Fairing Mid Support
Bracket supplied with this kit (Item 3).
Slide one M8 Thin Nut (Item 7) into the T-slot
of the front slat. Center the Mid Support
Bracket in the middle of the slat and secure
using a Schnorr Washer and M8 x 12 Button
Head (Items 8 & 9). Fully tighten.
Fit the chosen Light Bar Brackets LH / RH
(Item 4 or 5) using M8 x 16 Hex Bolts & M8
Nyloc Nuts (Items 10 & 11). Fit the Light Bar
and center on slat before fully tightening the
brackets.
Place M8 Nut Caps (Item 10) over all Hex
Bolts.
13mm
Torx
T30
Cordless
Drill
10mm
10mm
3
9
8
7
5mm
Keep screws in a safe place to use later.
See Fig 1.1 for which brackets are
suitable for your Light Bar
12
11
5
10