Installation Manual

RRAC195_REV_A01
© 2021 FRONT RUNNER VEHICLE OUTFITTERS
3
FIT AND SECURE 2
2.1
2.2
2.3
Remove the Slimsport Wind Fairing and Side
Support Brackets.
Loosen and remove the front slat.
Remove the wind fairing mid support
bracket that is currently on the slat and
replace it with the fairing mid support
bracket supplied with this kit (Item 3).
Slide one M8 Thin Nut (Item 7) into the T-slot
of the front slat. Center the Mid Support
Bracket in the middle of the slat and secure
using a Schnorr Washer and M8x12 Button
Head (Items 8 & 9). Fully tighten.
Fit Light Bar Bracket 01 LH / RH (Item 4) for
for Front Runner 40" light bar, using M8x16
Hex Bolt & M8 Nyloc Nut (Items 10 & 11).
Fit light bar and center on slat before fully
tightening the brackets.
Place M8 Nut Caps (Item 10) over all Hex
Bolts.
13mm
Torx
T30
Cordless
Driver
10mm
10mm
3
9
8
7
11
12
10
4
5mm
RH
LH