Installation Manual

RRAC171_REV_A00
© 2020 FRONT RUNNER VEHICLE OUTFITTERS
3
FIT AND SECURE 2
2.1
2.2
2.3
Slide four M8 Thin Nuts (Item 3) into each of
the two Slats (Item 1) as shown.
Assemble a RH Release Bracket (Item 4)
and a LH Release Bracket (Item 15) with two
Quick Release Bobbins (Item 14) to each
Slat (Item 1) using the Thin Nuts inserted in
2.1, four M8 Flat Washers, four M8 Spring
Washers, four M8x16 Button Head Screws
and four M8x30 Cap Screws (Item 5, 6, 7 &
13)
Measure 50mm from each slat end for
positioning of the Release Brackets and
Release Feet.
Ensure the correct orientation for the
Release Brackets (Item 4 & 5) on each slat
as shown.
Turn the assembled slat over and slide four
M8x35 Hex Head Bolts (Item 16) into the
assembled slats as shown.
1
16
1
1
3
3
1
4
15
7
6
5
14
13
50mm
50mm
5mm
6mm
Orientation Orientation