Installation Manual

RRAC169_REV _A02
© 2020 FRONT RUNNER VEHICLE OUTFITTERS
4
FIT AND SECURE 2
2.4
2.5
2.6
Place the Rack Mount Brackets (Item 3)
over the side profile, followed be the Rack
Support (Item 19) and secure using M8 x
25 Button Head Bolts, M8 x 30 Button Head
Bolts, M8 x 16 Hex Bolts, M8 x 16 x 1.6SS
Flat Washers and M8 Nyloc Nuts (Items 6,
7, 10, 13 & 20) as shown.
Finish off by placing M8 Nut Caps (Item 14)
on the Nyloc Nuts.
Measure the pitch of the Rack Mount
Brackets. Transfer the measurement over
to the Awning Brackets.
Fully tighten the Awning Brackets after you
have set them.
Finish off by placing Nut Cups on the Nyloc
Nuts.
Place the loop of the latch over the hook of
the Catch on the Mounting Bracket.
Close the Latch to secure the awning onto
the rack.
Do this with both latches.
5mm
3
20
It is recommended to mount the brackets
over a slat as shown is 2.4.
=
=
13mm
10mm
7
6
13
19
7
14
10
Rack Mount
Awning