Installation Manual

RRAC149_REV_A02 4
7
5
6
5
4
2
6
5
3
4
4
© 2019 FRONT RUNNER VEHICLE OUTFITTERS
FIT AND SECURE ON THE SIDE OF A SLIMLINE II RACK ONLY
3
The Lock must be pushed into the Locked
position when closing the Carrier in order for
it to latch.
3.1
3.2
3.3
Remove the Rubber Extrusion from the
Carriers. Refer to Step 2.1 & 2.2.
Secure the Carriers and the the Adjustable
Side Brackets using M8 x 16 Hex Bolts,
M8 x 16 x 1.6SS Flat Washers and M8 Nyloc
Nuts (Item 3, 4 & 5) as shown.
Replace the Rubber Extrusion and Clamp
Plates to the Carriers.
Finish by placing M8 Nut Caps (Item 6)
over the M8 Nyloc Nuts.
To mount the Carriers on the side of the Rack
you will need the Adjustable Side Brackets
(RRAC103 Sold Separately).
Decide where on the Rack you would like to
mount the Carrier. Find the correct spacing
best suited for the length of your Ski's,
Snow Board or Fishing Rod. Slide four M8
Nyloc Nuts (Item 5) into the Side Profile.
Place the Adjustable Side Brackets on the
Side Profile followed by the Support Bracket
(Item 2). Secure by using M8 x 25 Button
Head Bolts, M8 x 16 x 1.6SS Flat Washers
and M8 Nyloc Nut (Items 7, 4 & 5) as Shown.
Finish by placing an M8 Nut Cap (Item 6)
over the M8 Nyloc Nut.
13MM
13MM
Open
Closed
Adjustable Side Bracket
(RRAC103 Sold Separately)
13MM
5MM