Installation Manual

RRAC147_REV_A00
© COPYRIGHT 2018 FRONT RUNNER VEHICLE OUTFITTERS
4
FIT AND SECURE
3
2.2
2.3
2.4
2.1
3.1
3.2
3.3
INSTALLATION FOR MAX TRAX ONLY
Place the Max Trax over the preassembled
Mounting Plates to determine the spacing
required. Fully tighten the Mounting Plates
once the correct spacing has been achieved.
Ref to figure 3.1
Place Nut Caps (Item 7) over Nyloc Nuts.
Use the provided M10 Eye Nuts and
M10 x 30 x 3 SS Flat Washers (Items 13 & 14)
to secure the Max Trax.
4
2
6
1
5
13MM
INSTALLATION FOR TRED PRO / 1100 ONLY
Using the Tred Tracs as a guide place them
over the Mounting Plates to "determine" the
spacing required.
Secure using one Mounting Key per Mounting
Plate. Once the correct spacing has been
achieved "fully" tighten the Mounting Plates.
Ref to figure 3.1
10
14
Loosely secure the Mounting Plate
(Item 1) with four M8 Flat Washers and
four M8 Nyloc Nuts (Items 4 & 6).
(Mounting Plate assembly for Tred
Recovery Device shown in figure 3.1)
13