Installation Manual

ManualsBrandsFront Runner Manuals4WD & CampingWind Fairing for Rack / 1165mm/1255mm(W)

RRAC143

ENG

45 min

RRAC143_REV_A05

front runner

WIND FAIRING FOR RACK

1165MM / 1255MM(W)

Thank you for purchasing a Front Runner Wind Fairing for Rack / 1165mm / 1255mm(W).

Before you start, take a moment to familiarize yourself with the Fitting Instructions and the components received.

Refer to Page 2 for a list of all the components, quantities and tools required.

READ ME !

IMPORTANT WARNING!

IT IS CRITICAL THAT ALL FRONT RUNNER PRODUCTS BE PROPERLY AND SECURELY ASSEMBLED AND ATTACHED TO YOUR VEHICLE. IMPROPER ATTACHMENT COULD

RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH. YOU ARE RESPONSIBLE FOR ASSEMBLING AND SECURING ALL FRONT

RUNNER PRODUCTS TO YOUR VEHICLE, CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR AND

DAMAGE. THEREFORE, YOU MUST READ AND UNDERSTAND ALL OF THE INSTRUCTIONS AND PRECAUTIONS SUPPLIED WITH YOUR FRONT RUNNER PRODUCT PRIOR TO

INSTALLATION OR USE. IF YOU DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOROUGHLY

FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER OR OTHER QUALIFIED PERSONNEL.

NOTE: Front Runner will not be responsible for any damage caused by the failure to install the product according to these instructions.

Please call us if you have any questions about the installation of this product.

Summary of content (5 pages)

PAGE 1
front runner WIND FAIRING FOR RACK 1165MM / 1255MM(W) ENG RRAC143 45 min READ ME ! Thank you for purchasing a Front Runner Wind Fairing for Rack / 1165mm / 1255mm(W). Before you start, take a moment to familiarize yourself with the Fitting Instructions and the components received. Refer to Page 2 for a list of all the components, quantities and tools required. IMPORTANT WARNING! IT IS CRITICAL THAT ALL FRONT RUNNER PRODUCTS BE PROPERLY AND SECURELY ASSEMBLED AND ATTACHED TO YOUR VEHICLE.
PAGE 2
1 GET ORGANIZED TOOLS NEEDED IN THE BOX 1 2 3 4X 1X 1X RRAC142 Wind Fairing for Rack / 1165mm / 1255mm(W) Clear Protection Strip 3mm 4mm 13mm FIGURE 1.
PAGE 3
FIT AND SECURE 2 2.1 Start with removing the front right-hand Corner piece with a 4mm Allen Key. 4mm Slide 4 loosely assembled Wind Fairing Adjustable Brackets (Item 1) into the bottom T Slot as shown. Use either Slot A or B as shown in Figure 2.2. 2.2 Position the Wind Fairing Adjustable Brackets so that they line up with holes in the the Wind Fairing (Item 2). A B 1 2.3 Remove the M5x16 Countersink Screws & M5 Finishing Washers from the bracket.
PAGE 4
2 FIT AND SECURE Reﬁt Corner removed earlier in 2.1 2.4 4mm If your vehicle has a Roof Antenna which interferes with the Wind Fairing touching the roof. The knock out section can be removed. 2.5 KNOCK OUT SECTION 3 WIND FAIRING CARE Clean dust and debris build-up between the Rubber Trim and Clear Protection Strip at regular intervals. 4 FINISH Congratulations! You did it.
PAGE 5
INSTALL OTHER VEHICLE AND RACK ACCESSORIES Now's the time to visit your favorite Front Runner Dealer in person or online. Be sure to tag us.