Installation Manual

RRAC124_REV_A01
© COPYRIGHT 2017 FRONT RUNNER VEHICLE OUTFITTERS
5
12
4
6
7
13
11
10
6
9
8
FIT AND SECURE THE UNDER RACK MOUNT BRACKETS
3
Secure the light bar to the Mounting
Brackets using two M8 x 25 Hex Bolts, two
M8 Spring Washers, two M8 x 16 x 1.6SS
Flat Washers, the Spacer and M8 x 19 x 2SS
Flat Washers (Items 11, 10, 6, 9 & 8) as shown.
Finish of by placing M8 Nut Caps (Item 13)
over the M8 Hex Bolts.
3.1
3.2
3.3
Using a tape measure, space the Brackets
accordingly to suite the length of the light
bar you will be fitting.
Fully tighten the LH and RH Front Mounting
Brackets to the Rack.
Loosen and remove the wind deflector from
the Rack if it is already fitted.
Insert two M8 x 20 Hex Bolts (Item 12) into
the front slat using the machined slots
as shown.
Loosely fasten the two Under Rack Mount
Brackets (Items 3 & 4) to the M8 x 20 Hex
Bolts using M8 x 16 x 1.6SS Flat Washers
and M8 Nyloc Nuts (Items 6 & 7).
5MM
13MM
13MM