Installation Manual

RRAC124_REV_A01 3
© COPYRIGHT 2017 FRONT RUNNER VEHICLE OUTFITTERS
7
6
5
2
FIT AND SECURE THE FRONT MOUNT BRACKETS
2
2.1
2.2
2.3
Decide where you want to fit a light bar, on
the front, side or in the front or rear of the
Slimline II Rack.
If you fit the light on the front or rear of the
Rack, assemble three M8 x 20 Button Head
Bolts, three M8 x 16 x 1.6SS Flat Washers
and three Nyloc Nuts (Items 5, 6 & 7) to the
LH and RH Front Mount Brackets
(Items 1 & 2) as shown.
If you fit the light bar on the side, assemble
only the two top Button Head Bolts with
Washers and Nyloc Nuts as shown.
Remove the front right hand side corner
piece.
Slide the LH and RH Front Mount Brackets
into the Profile.
4mm