Installation Manual

FIT AND SECURE

2.2

2.3

2.4

2.1

2.7

2.8

2.9

2.10

Finally place items 10, 11 & 12 into the

T-Slot as shown. The Eye Nuts (Item 11)

will be used to secure the Board in place

on the carrier bracket when used in the

down position.

4MM

10MM

Lower the Vertical Surfboard Bracket

and position the Catch (item 3) so that it

ﬁrmly catches on the bar at the end of

the Vertical Surfboard Bracket.

Fully tighten the catch in place. Open and

close to check the operation of the catch,

if you are satisﬁed move on to the other

Vertical Surfboard Bracket.

RRAC095_REV_A01

With the Vertical Surfboard Bracket in the upright position, fully tighten the two M8 Nyloc Hex Nuts loosely

fastened in Step 2.6

Repeat Steps 2.2 through 2.8 to mount the second Vertical Surfboard Bracket.

Finish the installation by placing a M8 Nut Cap (Item 9) over all the M8 Nyloc Nuts (Item 8).