Installation Manual

BOTTLE OPENER MKII

RRAC077

INSTALL TIME: 5 Mins

REV_A00

MOUNTING THE BOTTLE OPENER

You will need:

 a 5 mm Hex Key

()

Decide where on your rack you would like to mount your Bottle

Opener. On the chosen side, slide the M8 Nyloc Nut (Dome side

down) into the "T-slot" channel through the gap in the corner

as shown.

Slide the Nyloc Nut down the "T-slot" channel to the desired

location.

()

Position the Bottle Opener above the

Nyloc Nut, lining up the hole in the top

of the Bottle Opener with the Nyloc

Nut. Fasten the Bottle Opener to the

rack using the Button Head Bolt and

Flat Washer supplied.

To open the bottle, insert the bottle

into the Opener as shown and lift /pull

the bottle upwards.

Congratulations, you have completed your installation. Take a step back and admire your work. Good Job!

PAGE 1
BOTTLE OPENER MKII RRAC077 INSTALL TIME: 5 Mins MOUNTING THE BOTTLE OPENER (A) You will need: a 5 mm Hex Key Decide where on your rack you would like to mount your Bottle Opener. On the chosen side, slide the M8 Nyloc Nut (Dome side down) into the "T-slot" channel through the gap in the corner as shown. Slide the Nyloc Nut down the "T-slot" channel to the desired location. (B) Position the Bottle Opener above the Nyloc Nut, lining up the hole in the top of the Bottle Opener with the Nyloc Nut.