Installation Manual

4
()
D
Install brackets and awning cont...
Insert two M8 x 16 Hex Bolts into the first and last Slats through the machined slot as indicated. Place the
left and right Support Brackets (Item 7) over the Hex Bolts and loosely secure the Brackets to the Rack
using four M8 Nyloc Nuts and four M8 Flat Washers (Items 4 & 5). Slide the Support Brackets up against
the Awning Brackets, lining up the holes in the Support Bracket with the holes in the Awning Bracket.
REV_A00
()
E
Looking at the rear of the Awning, insert a M8 x 16 Hex Bolt (Item 1) into either end of the two T-slot
channels and space according to the length of your Rack and position of the Mounting Brackets.