Installation Manual

3
(
INSTALL AXE BRACKETS SLIMLINE
)
II RACK
Decide where on your Rack you would like to mount your axe. Slide four M8 Nyloc Nuts (Item 8) in to the
"T-slot" rail on the chosen side by pushing the nuts through the gap in the Corner as indicated. Two of the
nuts will be used for the Head Bracket and two for the Handle Bracket. The spacing of the nuts and
brackets will depend on the length of your axe.
()
A
Using four of the M8 x 20 Button Head
Bolts and M8 Flat Washers (Items 6
&10), screw the Bolts into the M8
Nyloc Nuts (Item 8).
Grab the Head Bracket and slide it
between the two front or two rear
bolts (depending on how you are
mounting the axe. Ensure short side is
facing down). Position the Bracket as
required and hand tighten the bolts
using a 5mm Hex Key (The bracket
must still be able to move).
()
B
NOTE: Depending on which side of your Head Bracket you would like the axe handle to exit, you
may need to move the two Spacer Assemblies (one top, one bottom) to the opposite side. The
spacer assemblies must be on the same side that the handle exits the bracket.
(
C
)
Loosen the top Spacer
Assembly so that it is able to
move up and down. Slide the
axe through and into the
Head Bracket.
REV_B00