Installation Manual

3
Loosely assemble the spotlight bracket as per exploded view in section 1.
Remove a relevant corner from the rack by loosening the M5 Button head bolt with a 4mm Hex key and
sliding the corner off.
Slide the four Nyloc Nuts into the top and bottom T-slots of the rack and slide the bracket into required
position. Fasten all bolts securely using 5mm Hex key and 13mm wrench.
The angle of the bracket can be adjusted for various light mounting options by removing the M5 x 60 Allen
Cap Bolt, and selecting one of the three various 5mm locating holes.
FIT SPOT LIGHT BRACKET SLIMLINE II RACK
Loosely assemble the spotlight bracket as per exploded view in section 1, except items 2, 5 and 9.
Place the spotlight bracket over the side rail of rack in desired position and mark the location of the two
6mm holes with your marking pen. Using your drill and 6mm drill bit, drill the two holes you have just
marked on the rack.
Bolt the Bracket into position using the M6 x 16 Button Head Bolts, M6 Flat Washers and Nyloc Nuts
(items 2, 5 & 9).
The angle of the bracket can be adjusted for various light mounting options by removing the M5 x 60 Allen
Cap Bolt, and selecting one of the three various 5mm locating holes.
()
A
FIT SPOT LIGHT BRACKET SLIMLINE RACK
()
A
REV_B00