Installation Manual

3
MOUNTING YOUR BRACKETS
2
B)
Slide an M8 bolts into the aluminum slats T-slot, on the slat which you intent securing your Thule
extrusion. The head of the bolt can now slide up and down the slot. Bridge across two slats for the best
support. Drop the bracket onto the bolts and fasten with the M8 washer and nyloc nut.
From the bottom of the bracket push through the M6 bolt with an M6 washer, and spring washer.
Ensure the spring washer is seated between the bolts and the washer. Fasten with the M6 spring nut
on the opposite side of the bracket.
C)
Slide the Thule aluminum extrusion onto the spring nuts from the under side of the rack and fasten the
M6 bolts using your number 10 wrench. You can now add the plastic caps to the M6 bolts
Space and orient your brackets to suit your Thule Extrusion.
A)
The brackets are designed so that they can be mounted in many orientations to suit your need. They
can be mounted parallel with a slat or bridge across slats. They can also be mounted on top or below
the slat, depending on your personal preference.