Installation Guide

E
Lorem ipsum
LAVT001_REV_A01
© 2021 FRONT RUNNER VEHICLE OUTFITTERS
7
FIT AND SECURE 3
3.5
3.6
3.7
Use Denatured Alcohol and insure the
door is clean from any residue where
the bottom of the Ladder rests
against the door.
Remove the backing from the Dual
Lock Velcro at the bottom of the
Ladder and firmly push the bottom of
the Ladder against the body of the
vehicle.
D
FOR PERMANENT FITMENT, SKIP THIS
STEP AND CONTINUE TO 3.7.
Denatured
Alcohol
Ensure the top mount hooks from the
Ladder are against the top edge of the rear
door. Place the T6 - Pinch Bracket (Item
4) over the top mount hooks, lining up the
slotted hole in the Pinch Bracket with the
screw hole and the large clearance hole
over the left hinge bolt. Position the ladder
between the T6 - Pinch Bracket clamps as
shown.
Secure the Pinch Bracket to the vehicle
using the screw removed. Fully tighten.
Carefully close the rear door.
T50
Carefully open the rear door. Do not let the
rear door swing open.
Loosen and remove the right hand screw
on the left hand door hinge.
D
T50
D
E
T6 - VEHICLE FITMENT
T6 - VEHICLE FITMENT