Installation Manual
Remove
Remove
370mm
445mm
© 2022 FRONT RUNNER VEHICLE OUTFITTERS
5
KSTF001_REV_A03
PREPERATION
4
4.1
4.2
With the factory rails removed and starting at
the front edge of the molding, measure and
mark the dimensions as shown onto both the
LH & RH ditch moldings.
Use denatured alchohol and ensure the ditch
is clean from any residue where the Support
Plate 01 (Item 5) will be resting on the ditch.
Remove the backing from the double sided
tape on the bottom of the Support Plate 01
(Item 5) and push the plate firmly down onto
the body of the vehicle.
TEMPORARY FITMENT