Installation Manual

© 2022 FRONT RUNNER VEHICLE OUTFITTERS
3 KSTF001_REV_A03
ASSEMBLY
2
2.1
2.2
Secure the Splice Plates (Item 8) to the Foot
Rails (Items 1 & 2) as shown using M6 x 16
Flange Button Head Bolts and M6 Nyloc Nuts
(Items 13 & 14).
Secure the Stiffener Plates (Items 3, 4, & 5)
to the Foot Rails (Items 1 & 2) using M6 x 16
Flange Button Head Bolts and M6 Nyloc Nuts
(Items 19 & 10)
Do this to both LH & RH Foot Rails.
Place M6 Nut Caps (Item 11) over all Nyloc
Nuts.
Fit 10 Slimsport Slats (Item 7) to assembly
2.1 using M6 x 25 Thread Forming Screws
(Item 8).
Note do not fit front slat.
Apply a little oil on screw threads before
inserting. Note these are thread forming
screws.
33
10
11
4
10
11
1
2
6
10
11
10
11
5
7
8
Torx
T30
10mm
Torx
T30
Cordless
Driver
Tightening Torque 8-10Nm /
5.9 ft lb - 7.38 ft lb. Take care when
using a cordless driver.
Remove
Remove
370mm
445mm
With the factory rails removed and starting at
the front edge of the molding, measure and
mark the dimensions as shown onto both the
LH & RH ditch moldings.
3.1
PREPERATION
3