Installation Manual

RRAC194_REV_A02
© 2021 FRONT RUNNER VEHICLE OUTFITTERS
3
FIT AND SECURE 2
2.1
2.2
2.3
Remove the Slimsport Wind Fairing and Side
Support Brackets.
Loosen and remove the front slat.
Remove the Wind Fairing Mid Support
Bracket that is currently on the slat and
replace it with the Fairing Mid Support
Bracket supplied with this kit (Item 3).
Measure 452.5mm inward from both ends
of the slat and center both Mid Support
Brackets on these points. secure using a
Schnorr Washer and M8x12 Button Head
(Items 8 & 9). Fully tighten.
Fit the Light Bar Bracket 01 (Item 4) for for
frontrunner 40" light bar, using M8x16 Hex
Bolt & M8 Nyloc Nut (Items 10 & 11). Fit light
bar and center on slat before fully tightening
the brackets.
Fit the Light Bar Bracket 01 (Item 4) for for
Front Runner 40" light bar, using M8x16 hex
bolt & M8 nyloc nut (Items 10 & 11). Fit light
bar and center on slat before fully tightening
the brackets.
Place M8 nut caps (Item 12) over all hex
bolts.
13mm
Torx
T30
Cordless
Driver
10mm
10mm
3
9
8
7
11
12
10
4
5mm
452.5mm
452.5mm
Keep screws to one side to use later.