Installation Manual

Secure the support plates (Item 3) to the
Foot Rails (Item 1) using M6x16 Button Head
Flange Bolt , M6 Nyloc Nut & M6 Nut Cap
(Items 12, 16 & 18).
Secure the Side Wind Fairing Supports
(Item 2) to the Foot Rails (Item 1) using
M6x16 Button Head Flange Bolt , M6 Nyloc
Nut & M6 Nut Cap (Items 12, 16 & 18)
3
KSFF001_REV_A04
FIT AND SECURE
2
2.1
2.2
Assemble the Stiffener Pates (Item 2) to
the foot rails (Item 1) using M6x16 flange
button heads, M6 nyloc nut & M6 nut cap
(Items 5, 9 & 11).
Do this to both LH & RH foot rails.
Fully tighten.
Fit seven Slimsport Slats (Item 3) to foot rails
assemblies using M6x25 thread forming
screws (Item 12).
.
© 2022 FRONT RUNNER VEHICLE OUTFITTERS
12
3
1
1
2
11
9
5
1
Note do not fit the Front Slat.
Use a little oil on screw threads before
inserting. Note these are Thread
Forming Screws.
10mm
Torx
T30
Torx
T30
Cordless
Driver
Cordless
Driver
Tightening Torque 8-10Nm /
5.9 ft lb - 7.38 ft lb. Take care when
using a cordless driver.