Installation Manual

FIT YOUR side RAILS

Slide five M8 Nyloc Nuts (Item 3) dome side

down into the U-channel that runs down each

side of the Rack through the gap in the corner

of the Rack as shown to the right. Due to the

oint in the Rack you will need to slide three

nuts from one corner and two nuts form the

opposite corner as shown. Position the five nuts

each side as indicated by the balloons.

() A

REV_A01

Place one End Piece and the Joiner Pieces (Items 2, 5) onto either side of the Rack, making sure that the

"Feet" of the End and Joiner Pieces sit inside the U-channel as shown. Line up the mounting holes in the

End and Joiner Pieces with the Nyloc Nuts inserted in Step 2A and loosely secure them to the Rack using

the M8 x 25 Button Head Bolts (Item 1) supplied.

( b )