Installation Manual

1
EXPEDITION FULL RAIL KIT
KRX*002
INSTALL TIME: 30 mins
REV_A02
IMPORTANT WARNING!
IT IS CRITICAL THAT ALL FRONT RUNNER PRODUCTS BE PROPERLY AND SECURELY ASSEMBLED AND ATTACHED TO YOUR
VEHICLE. IMPROPER ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY
INJURY OR DEATH TO YOU OR TO OTHERS. YOU ARE RESPONSIBLE FOR ASSEMBLING AND SECURING ALL FRONT RUNNER
PRODUCTS TO YOUR VEHICLE, CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE
PRODUCTS FOR ADJUSTMENT, WEAR, AND DAMAGE. THEREFORE, YOU MUST READ AND UNDERSTAND ALL OF THE
INSTRUCTIONS AND CAUTIONS SUPPLIED WITH YOUR FRONT RUNNER PRODUCT PRIOR TO INSTALLATION OR USE. IF YOU DO
NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT
THOROUGHLY FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A
PROFESSIONAL INSTALLER OR OTHER QUALIFIED PERSONNEL.
IMPORTANT INFORMATION
If your Rack has already been fitted to your vehicle, you will need to remove the Rack in order to fit the
Expedition Rails. Start by removing all heavy items from the Rack. Depending on the mounting system used
follow one of the three steps listed below to remove the Rack.
LEGS:
Loosen and remove all the Clamps securing the Legs to the vehicle's gutters. Lift the Rack and walk it
backwards and off the vehicle. Take care not to scratch the vehicle roof.
Track & Feet:
Loosen and remove all of the MIDDLE bolts securing the top and bottom halves of the feet
together. Lift the Rack and walk it backwards and off the vehicle. Take care not to scratch the vehicle roof.
Foot Rail:
Loosen and remove all the nyloc nuts securing the Rack to the Foot Rails. Lift the Rack and walk it
backwards and off the vehicle. Take care not to scratch the vehicle roof.