Installation Manual

5
REV_A00
FIT YOUR EXPEDITION RAILS Cont...
Assemble Pipes B (Item 7) to the side of the Rack as shown below. Once in position secure the End Pieces
in place.
( )
G
Depending on the width and length our your Rack the two Steel Pipes that go on the side of the Rack may
need to be cut shorter in order to fit onto the Rack correctly.
If either of the rear Pipes (Pipe A) are loose once your Expedition Rail has been assembled, you can
loosen the appropriate section of Pipe and insert a C-clip Spacer (Item 9) over the taper of the Joiner
or Corner as shown.
( )
h