Installation Manual

FIT YOUR EXPEDITION RAILS

Decide whether you would like to fit your Expedition Rails to the front or rear of your Rack. Working on

the chosen side, loosen the M6 Button Head Bolt securing the left and right hand side corners in position

and remove the Corner of the Rack by pulling it away from the Rack.

( )

REV_A01

Loosely assembled a M8 x 25 Hex Bolt and

M8 Nyloc Not to the two End Pieces and

Joiner Piece (Items 1, 2, 3, 8).

( )

Referring to the images below, slide the two End Piece assemblies and the Joiner Piece assembly from

Step 2B into the "u" channel of the Rack as shown.

( )