Installation Manual

5
3
Before fitting the Wind Deflector, and with
the Rack in the upside down position, (Check
that the product sticker. It should be upside
down), slide a M8 x 20 Hex Bolt (Item 3) into
each end of the First Slat using the machined
slot as shown.
With your Rack still upside down position from Step 3A, slide a M8 x 20 Hex Bolt (Item 3) into either end of
each of the following Slats as per the diagrams below.
FIT THE RACK
( A )
( B )
Note: If your Slimline II Tray is not already assembled, assemble it as per the Slimline II Tray Universal
Assembly Instruction (Document RRSTUNI). Read Step 3A before fitting the Wind Deflector
FAVT001_REV_A00
Full Rack KRVK005T
Half Rack KRVK004T