Installation Manual

installation of slimline ii tray

KRTT900T / KRTT901T

INSTALL TIME: 15 mins

REV_A00

Toyota TACOMA

2005 Onwards

BED RACK LOAD BAR KIT

READ ME FIRST:

Thank you for purchasing a Front Runner Slimline II Load Bed Rack or Load Bar Kit.

Your Kit will contain the following items:

1.) A Slimline II Tray or Load Bar set

2.) Universal Load Bed Legs

3.) Bed Rail Nut Kit

This document will help you fit the Slimeline II Tray or Load Bars to your specific vehicle. If you are mounting

a Slimline II Tray, Please continue with Section 1. If you are fitting Load Bars, please refer to Section 2.

Note: When assembling the Legs, discard the Fittings Instructions received with the Legs (Document

LASS026) and assemble the Legs as per Assembly Instructions received with your Nut Kit (RRAC901). Not

all the components received with the Legs will be used as they will be replaced by the Nut Kit.

If your Slimline II Tray is not already assembled, assemble it as per the Slimline II Tray Universal

Assembly Instruction (Document RRSTUNI).

()

Remove End Cap and Slide two

Leg Assemblies into each Rail

PAGE 1
Toyota TACOMA 2005 Onwards BED RACK / LOAD BAR KIT KRTT900T / KRTT901T READ ME FIRST: Thank you for purchasing a Front Runner Slimline II Load Bed Rack or Load Bar Kit. Your Kit will contain the following items: 1.) A Slimline II Tray or Load Bar set 2.) Universal Load Bed Legs 3.) Bed Rail Nut Kit This document will help you fit the Slimeline II Tray or Load Bars to your specific vehicle. If you are mounting a Slimline II Tray, Please continue with Section 1.
PAGE 2
installation of slimline ii tray cont... (B) Adjust the two leg assemblies either side of the Midpoint of the factory rails so that they are 884 mm apart - outside to outside as shown below. (C) With your Rack in the upside down position ( Product Sticker should be upside down ) and working with the second Slat in, both front and rear, slide two M8 x 25 Hex Bolts supplied with the Universal Load Bed Legs into each end of the Slat using the machined Slots as shown.
PAGE 3
installation OF LOAD BARS INSTALL TIME: 15 mins Note: When assembling the Legs, discard the Fittings Instructions received with the Legs (Document LASS026) and assemble the Legs as per Assembly Instructions received with your Nut Kit (RRAC901). Not all the components received with the Legs will be used as they will be replaced by the Nut Kit.