Installation Manual

4
© 2020 FRONT RUNNER VEHICLE OUTFITTERS
KRTR002T_REV_A00
FIT AND SECURE
2
2.7
Loosley fit one Inner Grip and one Outer Grip
to each Grab On Foot using a M6 Cap Screw,
M6 Spring Washer and M6 Cap Screw
Washer removed.
Inner Grip
Outer Grip
5mm
FIT AND SECURE
3
2.2
2.4
2.1
3.1
3.2
4MM
Make sure that the wind deflector is
installed before you proceed to the next
step.
3.3
Center the rack and tighten fully. Finish off by placing M8 Nut Caps over the M8 Nyloc Nuts.
13mm
Place your Tray on the vehicle positioning all
the feet so that they rest on top of the roof
rails.
Measure 80mm from the front of the roof rail
where it is joined & position the LH and RH
front Grab On Feet as shown.
Fully tighten all the M6x50 Cap Screws to
secure the Tray onto the rails.
Refit the Front Cover Plates.
3mm
5mm
Tightening Torque 6Nm
Make sure there are no movement on
the rack after fully tightening all the
fasteners.
80mm