Installation Manual

A
B
© 2020 FRONT RUNNER VEHICLE OUTFITTERS
3 KRTR002T_REV_A00
FIT AND SECURE
2
2.1
2.2
2.3
Flip the Tray so that the bottom of the Tray
faces up.
Insert four M8x16 Hex Bolts into the
machined slots of the slats as shown.
Insert four M8x30 Hex Bolts into the Slats
machined slots as shown.
Loosely assemble the two Grab On Foot Sets
(Item 3) onto the slats indicated in 2.1 as
shown using M8 Flat Washers and M8 Nyloc
Nut.
Note one set of Spacers to be used on the
rear feet.
Refer to GOFR001 fitment guide.
Remove the Front Covers from all the Base
Feet by loosening the two M5x10 Button
Head Screws.
Loosen and remove the M6x60 Cap Screw,
M6 Spring Washer and Cap Screw Washer.
B
D
A
B
3mm
5mm
13mm