Installation Manual

Fit the foot rails

Remove the bolts and steel bracket below each Plastic Cover removed in Step 2B. The front and rear

brackets are secured with two bolts and the center brackets a secured using three bolts.

( C )

() A

Loosely join the Front and Rear Foot Rails (Items 7 & 8) together using the M6 x 16 Button Head Bolts, M6

Flat Washers, M6 Nyloc Nuts and Joiner Plates (Items 9, 10, 11, 12). Tighten all the Nuts and Bolts and

place a M6 Nut Cap (Item 13) over each Nyloc Nut.

Locate and remove the six Plastic Covers (three each

side) in the Ditch Moulding of the vehicle's roof. This

is done my pushing the covers towards the front or

rear of the vehicle and lifting.

() B

Clean the area around the threaded holes in the vehicle's roof using a rag and some methylated spirits /

denatured alcohol. Place some silicone around each threaded hole in the vehicle's roof and the cut-outs

in each of the Spacers (Item 14 & 15 ) as shown. Position the Spacers into the vehicle's gutters (silicone

side down, lining up the cut-outs in the Spacers with the threaded holes in the vehicle roof.

()

Silicone

FATL002 / KRTL029T_REV_A02