Installation Manual

© 2020 FRONT RUNNER VEHICLE OUTFITTERS
3 FATH003_REV_A01
FIT AND SECURE
2
13mm
2.1
2.2
2.3
Measure 295mm from the Tool Mark on
the Ditch Moulding and make a mark in
the Ditch.
Place the Template (Item 11) in the Ditch,
aligning the first hole with the mark you
just made. Mark all 4 Holes Clearly.
Remove the Template and drill a 4mm
Pilot hole on the 8 markings made (4 per
side). Re Drill the holes using a 7mm Drill.
From the Tool Mark on the Ditch Moulding,
measure 280mm toward the Front of the
Vehicle. Make a Line with a marker.
Place the Foot Rail on the Ditch Moulding,
with the heel of the Foot Rail against the
line made in Step 2.1
Mark the remaining foot positions.
Lift the moulding and trim out each section
where the Feet will sit. (2 per Foot Rail)
280mm
Rear of Vehicle
Rear of Vehicle
295mm
Rear of Vehicle
11