Installation Manual

© COPYRIGHT 2021 FRONT RUNNER VEHICLE OUTFITTERS
3 FATH002_REV_A04
FIT AND SECURE
2
2.1
2.2
2.3
2.4
2.5
From the Tool Mark on the Ditch
Moulding, measure 280mm toward the
Front of the Vehicle. Make a Line with a
marker.
Place the Foot Rail on the Ditch
Moulding, with the heel of the Foot Rail
against the line made in Step 2.1
Mark the remaining foot positions.
Lift Moulding and Trim out each section.
Where the Feet will sit. (2 per Foot Rail)
Measure 295mm from the Tool Mark on
the Ditch Moulding and make a Mark in
the Ditch.
Place the Template in the Ditch, Aligning
the first hole with the mark you just
made. Mark all 4 Holes Clearly.
Drill a 4mm Pilot hole on the 8 markings
made (4 per side). Re Drill the holes
using a 7mm Drill.
280mm
Rear of Vehicle
Rear of Vehicle
4mm Pilot
7mm Final
11
11
295mm