Installation Manual

RRAC021_REV_A01 3
© COPYRIGHT 2017 FRONT RUNNER VEHICLE OUTFITTERS
5
3
4
1
FIT AND SECURE
2
2.1
2.2
3.1
13MM
Loosely fit the Between Slat Foot Adaptors
(Item 1) using M8 x 16 x 1.6SS Flat Washers
and M8 Nyloc Nuts (Items 3 & 4).
Only fully tighten the the fasteners after you
have fitted your Front Runner Feet (Sold
Separately ) and centered the Rack on
your vehicle.
After fully tightening place M8 Nut Caps
(Item 2) over all the fasteners.
Slide two M8 x 16 Hex Bolts into the chosen
slats.
Repeat this on the opposite side of the Rack.
COMPLETION
3