Installation Manual

Fit the foot rails

REV_A02

Using a panel tool or flat screwdriver, remove the

front and rear end covers from the vehicle's roof

rail. Loosen the two bolts found underneath each

cover (as indicated by the arrows) and remove the

roof rails from the vehicle.

( )

Clean the area around the threaded holes in the vehicle's roof using a rag and some methylated spirits /

denatured alcohol. Place some silicone around each threaded hole in the vehicle's roof and the two

cut-outs in each of the Spacers (Item 8) as shown. Position the Spacers into the vehicle's gutters, lining

up the cut-outs in the Spacers with the threaded holes in the vehicle roof.

( )

Silicone

( )

Place the assembled Foot Rails (Item 6) onto the vehicle's roof, lining up the mounting holes in the bottom

of the Foot Rails with the mounting points on the vehicle. The Product Sticker must go to the rear of the

vehicle and must be facing outwards. Push the Foot Rails as far back as possible.

Product Sticker

Secure the Foot Rails to the vehicle using the M8 x 40 Hex Bolts, M8 Spring Washer and M8 Flat Washers

(Items 2, 3, 4). Place a M8 Nut Cap (Item 1) over each Bolt Head once fastened.

( )