Installation Manual

© COPYRIGHT 2017 FRONT RUNNER VEHICLE OUTFITTERS
3 FATF004_REV_A01
FIT AND SECURE THE FOOT RAIL
2
13mm
2.1
2.2
2.3
Place a Spacer (Item 90) into each of the
mounting point recesses, lining up the
holes in the Spacer with the bolt holes in
the roof. Ensure that the wide section of
the Spacers (as indicated in the image) go
towards the outside of the vehicle.
Unclip and remove the six covers on the
top of the vehicle's roof to expose the
vehicle's mounting points. There are three
on each side of the roof in the front,
middle and rear.
Remove the 8mm Bolts indicated by the
arrows.
Clean the area around the bolt holes using
a rag and methylated spirits/denatured
alcohol. Place some silicone over each bolt
hole.
10mm
Narrow
Wide
9