Installation Manual

4
3
Before fitting the Wind Deflector, and with
the Rack in the upside down position,
(Check with product sticker. It should be
upside down), slide a M8x20 Hex Bolt into
each end of the First Slat using the
machined slot as shown.
FIT THE RACK
()
A
Note: If your Slimline II Tray is not already assembled, assemble it as per the Slimline II Tray Universal
Assembly Instruction (Document RRSTUNI). Read Step 3A before fitting the Wind Deflector
REV_A00
FIT the Foot RAILS Cont...
()
D
Product Sticker
Place the Rear Foot Rails (Item 2) onto
the vehicle lining up the mounting holes
in the Foot Rails with the mounting holes
in the roof. The product sticker goes to
the rear and outside of the vehicle.
Starting from the front, loosely fasten the
Foot Rails to the vehicle using the M8 x
35 Hex Bolts, M8 Flat Washers and M8
Spring Washers (Items 3, 7, 8) supplied.
Tighten all bolts securing the Foot Rails
to the vehicle and place a M8 Nut Cap
(Item 5) over each Bolt.