Installation Manual

3
Fit the foot rails
Carefully remove the two end caps, front and rear on each Roof Rail and undo the nuts securing the Roof
Rails to the vehicle.
() A
REV_A01
() B
Place a Foam Pad (Item 4) over each set of mounting studs found in the vehicles roof.
() C
Place Foot Rails (Item 9) onto the vehicle's roof, lining up the holes in the Mounting Feet with the studs in
the vehicle's roof. Loosely secure the Foot Rails to the vehicle using the M6 x 19 Flat Washers and M6
Nyloc Nuts (Items 2 & 3 ) supplied. Push the Foot Rails as far back as possible and tighten the Nyloc Nuts.
Place a M6 Nut Cap (Item 1) over each of the Nyloc Nuts.
Rear of Vehicle
Front of Vehicle