Installation Manual

© 2021 FRONT RUNNER VEHICLE OUTFITTERS
3 KRSA001T_REV_A01
FIT AND SECURE
2
2.1
2.2
2.3
Flip the Tray so that the bottom of the Tray
faces up.
Insert four M8x35 Hex Bolts into the Slats
machined slots as shown.
Insert four M8x20 Hex Bolts into the Slats
machined slots as shown.
Insert four M8x35 Hex Bolts into the Slats
machined slots as shown.
Loosely assemble the three Grab On Foot
Sets (Item 3) onto the slats indicated in 2.1
as shown using M8 Flat Washers and M8
Nyloc Nut.
Note: One spacer to be used on the front feet
and two spacers on the rear feet.
Refer to GOFR001 fitment guide.
Remove the Front Covers from all the Base
Feet by loosening the two M5x10 Button
Head Screws.
Loosen and remove the M5x60 Cap Screw,
M5 Spring Washer and Cap Screw Washer.
B
D
A
3mm
5mm
13mm
B
A
C
B
C