Installation Manual

ManualsBrandsFront Runner Manuals4WD & CampingNissan Xterra N50 Slimline II Roof Rack Kit

NISSAN EXTERRA

SLIMLINE II RACK

(

1165MM X 1964mm

)

FANX002 / KRNX005T

INSTALL TIME: 60 mins

REV_A00

IMPORTANT WARNING!

IT IS CRITICAL THAT ALL FRONT RUNNER PRODUCTS BE PROPERLY AND SECURELY ASSEMBLED AND ATTACHED TO YOUR

VEHICLE. IMPROPER ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY IN-

JURY OR DEATH TO YOU OR TO OTHERS. YOU ARE RESPONSIBLE FOR ASSEMBLING AND SECURING ALL FRONT RUNNER

PRODUCTS TO YOUR VEHICLE, CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE PROD-

UCTS FOR ADJUSTMENT, WEAR, AND DAMAGE. THEREFORE, YOU MUST READ AND UNDERSTAND ALL OF THE INSTRUCTION

AND CAUTIONS SUPPLIED WITH YOUR FRONT RUNNER PRODUCT PRIOR TO INSTALLATION OR USE. IF YOU DO NOT UNDER-

STAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOR-

OUGHLY FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSION

AL INSTALLER OR OTHER QUALIFIED PERSONNEL.

READ ME FIRST:

Thank you for purchasing a Front Runner Slimline II Rack.

This Roof Rack consists of a kit that contains:

1.) A Slimline II Tray

2.) A mounting system specific to your vehicle

This document will hel

ou fit the Slimeline II Tra

our s

ecific vehicle.

Summary of content (5 pages)

PAGE 1
NISSAN EXTERRA SLIMLINE II RACK (1165MM X 1964mm) FANX002 / KRNX005T INSTALL TIME: 60 mins READ ME FIRST: Thank you for purchasing a Front Runner Slimline II Rack. This Roof Rack consists of a kit that contains: 1.) A Slimline II Tray 2.) A mounting system specific to your vehicle This document will help you fit the Slimeline II Tray to your specific vehicle. IMPORTANT WARNING! IT IS CRITICAL THAT ALL FRONT RUNNER PRODUCTS BE PROPERLY AND SECURELY ASSEMBLED AND ATTACHED TO YOUR VEHICLE.
PAGE 2
GET ORGANIZED... Here is what you are looking at for FANX002: Please note that only the right hand side's components have been shown.
PAGE 3
FIT the Foot RAILS (A) Using the Torx Driver received in your vehicles' tool kit, loosen and remove the vehicles' roof rack/rails. (B) Using the fourteen M6 x 20 Button Head Bolts (Item 11) supplied, place a small amount of silicone on the thread of each bolt and secure them to the mounting points in Set B, thereby sealing the mounting points.
PAGE 4
3 FIT THE RACK Note: If your Slimline II Tray is not already assembled, assemble it as per the Slimline II Tray Universal Assembly Instruction (Document RRSTUNI). Read Step 3A before fitting the Wind Deflector (A) Before fitting the Wind Deflector, and with the Rack in the upside down position, (Check with product sticker. It should be upside down), slide a M8 x 20 Hex Bolt (Item 6) into each end of the First Slat using the machined slot as shown.
PAGE 5
TAKE A TRIP (A) After your first adventure, check that all nuts, bolts, screws and fittings are tight. Re-tighten where needed. You'll find a small amount of settling has happened. Go on many more adventures, periodically checking all nuts, bolts, screws and fittings. Front Runner can not recommend a maximum load carrying capacity. Please refer to your vehicle manufacturer's recommendations.