Installation Manual

FAMP001_REV_A01_MV

2.1

2.2

2.3

2.4

2.5

Clean the area around all of the

mounting points on the vehicle's roof

using a rag and methylated spirits or

denatured alcohol.

Place some Silicone over each hole.

Place the three different sized spacers

(Items 4, 5 & 8) into each corresponding

"mounting recess" as shown.

Place silicon onto the bolting plates

Items 3, 6 and 9.

Fit Front and Rear Foot Rail Item 1 and 2

loosely with Items 11, 12, 13 and the

corresponding bolting plate.

Large Half Moon

Inside of vehicle

Front of vehicle

Small Half Moon

To achieve this installation you will need to drop the interior roof lining and remove the factory roof rails.

Tools needed are not listed.

FIT AND SECURE

10mm