Installation Manual

FALF002_REV_A00
© 2021 FRONT RUNNER VEHICLE OUTFITTERS
3
FIT AND SECURE
2
2.1
2.2
2.3
Using a suitable panel tool, remove the ditch
moulding on the left and right side of the
vehicle.
Remove the factory plastic clips as shown.
Using a Suitable panel tool, remove the
plastic clips at the rear.
Measure and mark the hole positions on
the ditch moulding as shown in 2.3. The
positions must be centered on the moulding.
Drill a 4mm pilot hole on the markings you
made. Open the pilot holes using a 7.5mm
drill.
Slide the 6mm Spacer (Item 10) into the
opening of the ditch mouling after all holes
has been drilled, make sure the notch is
facing outwards as shown.
Clip the ditch moulding back into place.
Panel
Tool
4mm
7.5mm
Front of Vehicle
68mm
29mm
10
10
Panel
Tool