Installation Manual

4
Fit the foot rails Cont...
REV_A02
Clean the area around each of the threaded mounting points and apply some silicone over each point.
Place three Spacers (Item 8) over each of the front and middle mounting points and four Spacers on each
of the rear mounting points as shown. The Spacers must be placed with the wider section towards the
outside of the vehicle.
( )
D
WIDER SECTION TOWARDS OUTSIDE OF VEHICLE
( )
E
Place the assembled Foot Rails onto the vehicle's roof, lining up the mounting holes in the bottom of the
Foot Rails with the mounting points on the vehicle. The Product Sticker must go to the rear of the vehicle
and must be facing outwards. Push the Foot Rails as far back as possible.
Product Sticker
(
F
)
Secure the Foot Rails to the vehicle using the M8 x 40 Hex Bolts, M8 Spring Washer and M8 x 19 Flat
Washers (Items 2, 3, 4). Place a M8 Nut Cap (Item 1) over each Bolt Head once fastened.