Installation Manual

© 2020 FRONT RUNNER VEHICLE OUTFITTERS
3 FALD004_REV_A02
FIT AND SECURE
2
2.1
2.2
2.3
Using your torx wrench, loosen and remove
the original factory tracks. If your vehicle did
not come with these tracks, refer to 2.4.
Use a small flat screwdriver and remove
the plastic cap in the front ditch molding
on either side of the sun roof to expose the
threaded mounting points.
If your ditch moldings do not have the plastic
caps,you will need to remove and drill holes
in the ditch moldings. the position of the
mounting points are best marked onto the
ditch moldings by screwing a sharpened m6
bolt with its head cut off into the mounting
point, sharp side up. Place the ditch molding
back on the vehicle and push on the area
above the sharpened bolt, therby marking the
ditch moldings.
Loosely join the Front and Rear Foot Rails
(Items 6 & 13) together using M6 x 16 Button
Head Bolts, M6 Nyloc Nuts and the Joiner
Plate (Items 10, 11 & 12) as shown.
12
11
10
1
13
6