Installation Manual

FIT the Foot RAILS

Using your Torx Wrench, loosen and remove the two original tracks if fitted. If your vehicle didi not come

with these tracks, refer to Step 2D.

()

REV_A01

Use a small flat screwdriver and remove the plastic

cap in the front ditch molding on either side of the

sun roof to expose the threaded mounting points.

()

Loosely join the Front and Rear Foot Rails together using the M6 x16 Button Head Bolts, M6 Flat Washers,

M6 Nyloc Nuts and Joiner Plates (Items 7, 8, 9, 10).

If your ditch moldings do not have the plastic caps,

you will need to remove and drill holes in the ditch

moldings. The position of the mounting points are best

marked onto the ditch mouldings by screwing a

sharpened M6 bolt with its head cut off into the

mounting point, sharp side up. Place the ditch

molding back on the vehicle and push on the area

above the sharpened bolt, therby marking the ditch

moldings.