Installation Manual

4
REV_A02
FIT the Foot RAILS cont...
Place the assembled Foot Rails onto the vehicle lining up the front mounting holes in the Foot Rail with
the front mounting holes in the roof of the vehicle from Step 2B. Loosely fasten the front mounting foot of
the Foot Rail to the vehicle using the M6 x 20 Hex Bolts, M6 x 19 Flat Washers and M6 Spring Washers
(Items 2, 3, 4) supplied.
Mark the position (front and rear) of the three mounting feet onto the ditch moulding. Remove the foot rail
and ditch moulding. Cut the ditch moulding 5 mm in from each of your markings and discard the pieces
where the mounting feet sat. Reposition the ditch moulding pieces in their original position, leaving gaps
where the Foot Rails mounting feet are positioned. Continue to Step 2E.
()
D
Only complete Step 2D if your vehicle did not come fitted with the original tracks refered to in Step 2A.
Place the assembled Foot Rails onto the vehicle lining up the mounting holes in the Foot Rails with the
mounting holes in the roof. Starting from the front, place the Cover Plate (Item 5) on top of the Foot Rails
as shown and loosely fasten the Foot Rails to the vehicle using the M6 x 20 Hex Bolts, M6 x 19 Flat
Washers and M6 Spring Washers (Items 2, 3, 4). Line up the joint from Step 2C and fasten. Push the Foot
Rails towards the rear of the vehicle and tighten all bolts securing the Foot Rails to the vehicle. Place a
M6 Nut Cap over each of the Hex Bolts securing the Foot Rails to the vehicle and the Nyloc Nuts used to
fasten the Joiner plates.
()
E
Cover Plate