Installation Manual

5
installation OF LOAD BARS
Note: If you have not fitted the Universal Load Bed Tracks or Legs, please fit them as per the Universal
Load Bed Track and Universal Load Bed Led Fitting Instructions (Documents TRBU001 & LASS026).
()
B
Fit a Plastic End Caps received with your Load Bars into each end of the Load Bars as shown.
() C
With the Load Bars in the upside down position (Check using
the Buck Logo on End Caps from Step 2B as an indicator),
slide two M8 x 25 Hex Bolts supplied with the Universal Load
Bed Legs into each end of the Load Bars using the machined
slots as shown.
Slide an End Cap (Item 3) into the ends of
Track and secure in position using the
M3 x 6 Self Tapping Screw (Item 1).
() A
TRBU003 / KRLBUNI3_REV_A00